Do you always replace the floor or can it be injected?

If the issue is delamination without active rot, resin injection can bond the layers and restore rigidity. Where timber or core is rotten, we replace the affected section for a lasting fix.

Will you fix the cause of the water ingress?

Yes. We identify and address the source (e.g. trims, awning rails, rooflights) before repairing the floor, then re-test moisture to confirm.

How long does a floor repair take?

Minor delamination can be completed relatively quickly. Structural replacement takes longer due to drying and curing times. We confirm timelines after assessment.

Is this covered by insurance?

It depends on the cause and your policy. We provide insurer-ready estimates with photos and can liaise with your insurer or broker.

Floor Rot Repairs for Motorhomes & Caravans | Motorhome Kings (AWS Approved)

AWS Approved Workshop

Floor Rot & Delamination Repairs – Motorhomes & Caravans

Soft floors or spongey patches? We diagnose, dry and repair using the right method — resin injection, board/insulation replacement and re-lamination. Insurance-friendly, factory-standard finish.

Request Floor Repair Assessment

Prefer the phone? 0191 694 1111 • info@motorhomekings.uk

Common Signs

Soft, springy or “spongy” feel underfoot
Floor creaks or movement around kitchen/door areas
Delamination — top layer lifting from the core
Previous damp issues near awning rails, corners or wheel arches

Typical Causes

Water ingress (failed seals, impact damage)
Age-related adhesive failure between layers
Heavy point loading or historic repairs done poorly

How We Repair Floor Rot & Delamination

Assessment & Drying

Moisture mapping to confirm cause and extent. We dry thoroughly before any structural repair.

Resin Injection

For minor delamination: injected structural resin bonds layers, restoring rigidity without full strip-out.

Board Replacement

For rot or widespread failure: lift affected sections, replace plywood/foam core and re-bond.

Insulation Renewal

Wet insulation is removed and replaced to maintain thermal performance and prevent future issues.

Re-lamination & Finish

Re-bond layers, clamp, and finish with appropriate coverings, trims and sealants.

Proof & Aftercare

Final checks and moisture readings. We advise on prevention and maintenance intervals.

Start Your Assessment Request

Our Process

Inspect — confirm cause & extent with moisture mapping.
Quote — method (inject or replace), timeline & cost.
Repair — dry, inject/replace, re-laminate and refit.
Sign-off — final readings & aftercare guidance.

Every floor is different. We choose the **least invasive** method that actually lasts.